Pendant Mount Installation
Required Tools and Materials
The following tools are required to complete the installation but are not included in the package:
l Appropriate tool for cutting the cable access hole, if required
l Small slotted screwdriver with 5/64” or 2 mm blade width — for connecting power when not using
Power over Ethernet
If you will be installing the NPT adapter (H5A-FE-MT-NPTA1), you will need:
l 1-1/2" NPT female to female adapter
l NPT pipe
Camera Package Contents
Ensure the surface mounted camera package contains the following:
l Avigilon H5A Fisheye Camera
l Camera Base Mounting Template sticker
l Optional wall plate adapter — for electrical box installations.
l Star-shaped screwdriver
l Power terminal block
l Optional conduit shroud — for side-entry conduit cabling.
l 3x screws and anchors — for securing the camera to the mounting surface.
l 3-hole rubber grommet — for multi-cable installations.
l Single-hole rubber grommet — for installations with a single Ethernet/PoE cable.
l RJ45 grommet piercing cap — for use with single-hole rubber grommet only
If you are using the optional NPT adapter (H5A-FE-MT-NPTA1), ensure the package contains the following:
l NPT adapter for the H5A Fisheye Camera
l Lock nut
l Thread seal tape
Installation Steps
Complete the following sections to install the device.
Mounting the Camera to a Pipe
If the camera needs to be installed to a pipe for a pendant installation, you use the NPT adapter (H5A-FE-
Pendant Mount Installation 43
To Next Page
Loading...
