Surface Mount Installation
Required Tools and Materials
The following tools are required to complete the installation but are not included in the package:
l Appropriate tool for cutting the cable access hole
l Small slotted screwdriver with 5/64” or 2 mm blade width — for connecting power when not using
Power over Ethernet
l No. 2 Phillips screwdriver — for attaching camera to an electrical box or mounting surface
Camera Package Contents
Ensure the surface mounted camera package contains the following:
l Avigilon H5A Fisheye Camera
l Camera Base Mounting Template sticker
l Optional wall plate adapter — for electrical box installations.
l Star-shaped screwdriver
l Power terminal block
l Optional conduit shroud — for side-entry conduit cabling.
l 3x screws and anchors — for securing the camera to the mounting surface.
l 3-hole rubber grommet — for multi-cable installations.
l Single-hole rubber grommet — for installations with a single Ethernet/PoE cable.
l RJ45 grommet piercing cap — for use with single-hole rubber grommet only
Installation Steps
Complete the following sections to install the device.
Mounting in the Correct Orientation
The H5A Fisheye camera provides 360° views of large areas. Because of the 360° view, it is not obvious
which part of the camera should be facing up when installed on a wall. To help with this, the mounting
template and the camera body have an up orientation arrow printed on them to signal which end should be
facing up.
When installing the camera on a ceiling, the orientation arrow can go in any direction.
Surface Mount Installation 17
To Next Page
Loading...
Need help?
General
