Removing V300 Camera Battery
Removing V300 Camera Battery
You can remove the V300 battery and charge it separately from the camera. If you use a spare battery this
ensures you never run out of power.
Note: No events can be uploaded if the camera is not docked.
To remove the battery:
1. Power off the camera.
2. Slide the silver bar on the back of the camera to the left.
3. Pull straight down on the battery. Do not lift out.
To replace the battery, slide it into the tracks and push it in until it clicks.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
17
To Next Page
Loading...
Need help?
General
