About the Transfer Station II
About the Transfer Station II
You can dock the camera and battery together or dock the battery alone in the Transfer Station II.
When you dock the V300 Body-Worn Camera, the camera automatically starts charging, if needed. The
camera also uses the Transfer Station II to:
l Upload recorded events from storage
l Upgrade the V300 Camera
l Update firmware
Evidence Library can interact with multiple V300 Body-Worn Cameras simultaneously while in Transfer
Station II. Each Transfer Station II has eight slots for cameras or batteries.
LEDs
Three LEDs on each slot of the Transfer Station II show power and connection status:
l Green, left position: When lit, indicates that the Transfer Station II is powered on
l Amber, center position: When lit, indicates that the Transfer Station II is connected to Evidence Library
software; when blinking, indicates data is being transferred
l Red, right position: When lit, indicates an error condition
For more information on the LEDs, see the Transfer Station II Quick Start Guide.
Connections
The Transfer Station II has connections for both a power cable and an Ethernet cable. You power the
Transfer Station II off and on using the power switch.
see Docking the V300 Camera in a Transfer Station II on page 30
V300 Body-Worn Camera User Guide
WGD00169, Revision B
73
To Next Page
Loading...
Need help?
General
