Motorola solutions V300 User Manual

MOLLE vest mount
Caution: WATCH YOUR FINGERS! Because of the strength of the magnets, separating
the brackets requires some effort. Realigning the brackets causes them to snap together
forcefully. Keep your hand flat and keep your fingers away from the snap-to area.
MOLLE vest mount
The MOLLE vest mount uses hooks to anchor the mount over two rows of loops
on the MOLLE vest.
Tip: Install the mount on the vest before you connect the camera to
the mount.
To use the MOLLE vest mount:
1. Determine which two rows of loops on the MOLLE vest you want to use to mount the
V300 Camera.
2. Slide the forked end down over the sewn seam, on the lower of the two rows, between the two loops until
the hook is engaged below the seam.
You may need to slightly twist the mount to help the hook slide over the seam.
3. Fold the fabric between the two rows so that the support loop hooks engage two loops on the upper row of
loops.
4. Slide the upper loop hooks down over the two loops, straightening the fabric between the rows, to fully
seat the mount.
The forked end should be fully engaged with the seam on the lower row of loops. The hooks should be
fully engaged with two loops on the upper row of loops.
5. Align the V300 Camera with the two tabs on the bottom of the mount and snap the camera in to the mount.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
21

Motorola solutions V300 Specifications

General

Brand	Motorola solutions
Model	V300
Category	Digital Camera
Language	English