Upgrading V300 Body-Worn Camera Firmware
Upgrading V300 Body-Worn Camera
Firmware
You can push new firmware upgrades to the V300 Camera while it is docked in the Transfer Station II. You
can push an upgrade automatically when it is docked (depending on your configuration).
Important! Do not remove the battery while the upgrade is in progress.
l WiFi base
You can push an upgrade to the V300 Body-Worn Camera when it is docked in a WiFi base, only if the
WiFi base has access to Evidence Library (EL) upload server. The upgrade is pushed automatically.
When an upgrade is pushed to the camera, the firmware is first staged on the camera, then the upgrade is
applied.
To upgrade the V300 Body-Worn Camera firmware:
1. Dock the camera in a WiFi base or Transfer Station II with access to EL.
EL
V300 checks EL for firmware upgrades.
2. Keep the camera docked while upgrading.
Warning! DO NOT REMOVE the camera from the dock while its new firmware is being
applied. Removing the camera from the dock during the upgrade can cause the camera to
stop functioning. The camera cannot perform any other function, including uploading video,
while it is upgrading its firmware.
While the upgrade is being staged on the camera, the LCD shows DONOTINTERRUPT under the
upgrade bar.
When the upgrade has finished applying, the camera sounds the ready alert (depending on your alert
notification selections). You can safely undock the camera.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
35
To Next Page
Loading...
