Stopping a recorded event manually
Stopping a recorded event manually
To manually stop a recorded event on the V300:
n Press the Record Start/Stop button.
n Press the Record Start/Stop button a second time within 5 seconds to
Important! The V300 can be configured in EL to NOT allow manual event stop.
On the camera the display and the front red LED turn off and the top LED turns green.
After a recorded event stops, if your configuration requires event categorization, the event categorization
sequence starts (page 27).
Tip: Your V300 automatically starts an event whenever any member of the local recording
group reports that it started a group event. To STOP the group event, press the Record
Start/Stop button twice within 5 seconds.
Covert mode
In Covert mode the V300 Camera makes no sound and is dark. The display backlight can light up on
demand, depending on your configuration. The camera can still vibrate in Covert mode (depending on the
configured alert notifications). All V300 functions operate the same way in Covert mode as they do in
normal mode. Whether Covert mode is available is configurable.
Enter Covert mode
n Press and hold the Function button for 5 seconds to transition to Covert mode.
The camera vibrates and the display shows READY, then COVERT
The display changes from black on white to white on black during Covert mode. All
content on the display is the same in Covert mode as in normal mode.
Exit Covert mode:
n Press and hold the Function button for 5 seconds to end Covert mode (LEDs on, display backlight on).
The Evidence Library administrator sets officer access to Covert mode.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
25
To Next Page
Loading...
Need help?
General
