Appendix: Transfer Station II
Administrative functions
Only an Admin can perform the functions shown here.
Change Username and Password
Go to the same web portal where you configured IP addresses and EL settings to change the default
Username and Password:
1. Enter a new Username.
2. Enter a new Password.
3. Click Save Changes.
Because the login credentials changed, the server logs you out of the Transfer Station II then asks you
to log in using the new credentials.
Disable Transfer Station II
Disable can function as another level of security. Disabling the configuration page, after you finish
configuring the Transfer Station II, prevents others from accessing the configuration page to make
unauthorized changes. This includes other authorized administrators. To configure the Transfer Station
II after disabling, reset the Transfer Station II back to factory defaults.
Note: To reset the Transfer Station II to factory defaults, use a pin or paper clip, press
and hold the Reset button for at least 7 seconds. The button is on the bottom of the
Transfer Station II.
78
V300 Body-Worn Camera User Guide
WGD00169, Revision B
To Next Page
Loading...
