Docking the V300 Camera Overview
Docking the V300 Camera Overview
Dock the V300 to recharge the battery, upload evidence, and update firmware. You can dock the V300
from:
l WiFi base (upload from) (page 31)
l Transfer Station II (upload from) (page 30)
l USB base (charge only)
Note: The camera and battery can only dock in one direction on the bases. Do not remove
the camera from the battery while charging. You can damage files on the camera.
You can dock the V300 Camera with the battery or dock the stand-alone battery in any of the available
bases. Use the WiFi base for incidental charging during your shift. Charging in a vehicle base (WiFi or
USB), without the vehicle running, can impact the vehicle battery and can slow charging in warmer
temperatures.
Caution: If the ambient temperature gets too hot (40° C / 104° F) the battery may stop
charging.
While docked, you can:
l Charge the battery
l Upgrade firmware for the V300 Camera from Transfer Station II
l Upload recorded events from Transfer Station II
l Define a Record-After-the-Fact
®
(RATF) event
l Request a state capture from Transfer Station II for troubleshooting
l Upgrade the camera software (Transfer Station II only)
Note: The V300 must interact with Evidence Library (EL) to be customized for your
agency. For that interaction to take place, the camera must be docked in a Transfer Station
II with access to the computer running EL.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
29
To Next Page
Loading...
