Storage
Storage
The V300 Camera stores 24 to 36 hours of HD video at 1080 pixels. The camera uses a 128 GB SD Card.
When you need to free up storage space on the camera, upload recorded events (page 34) from the
camera to Evidence Library (EL).
The V300 display shows a Storage Used icon and percentage (50%) used for
protected recorded events. As the camera records events and its storage fills, the
Storage Used icon fills with black and the percentage increases.
Low storage and full storage messages
When the camera is about 10 minutes away from running out of storage space, it
alerts you with:
l Two short tones and/or a vibration (depending on your alert configuration settings)
l Slow-blinking red LED and Storage Used meter and icon on the display
When the camera storage is full, it alerts you with an error condition alert:
l Fast-blinking red LED
l Three short tones and/or a vibration (depending on your alert configuration settings)
l FULL message on the display
Warning! If storage fills completely, the camera stops recording new video.
GPS
The V300 Camera includes a built-in Global Positioning System (GPS). V300 uses the GPS feature to
apply:
l Accurate timestamps to recorded events
These timestamps allow Evidence Library (EL) to synchronize playback between events (video and/or
audio) from the V300 Cameras and a 4RE DVR.
l GPS location coordinates to the V300 recorded events
EL
The fix status, longitude, latitude, speed, and time of day information is sent to the Metadata service each
second so that it can be included in the event data. The speed information is compared to the configured
maximum speed to determine if the vehicle has exceeded the excessive speed trigger. If it has, a
message is sent to the Event service to determine if an event should be started.
Note: The GPS feature can be disabled in your EL configuration.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
55
To Next Page
Loading...
