Docking the V300 in a WiFi base
When you undock the camera and battery from the Transfer Station II, they are ready for normal operation.
Docking the V300 in a WiFi base
You can dock the V300 in one direction only. The camera pairs with that base and with any other V300
Cameras that pair with the base.
When you dock the camera and battery in a WiFi base that is connected to a computer that has access to
Evidence Library (EL), the camera communicates to EL that it has recorded events to upload
Note: The camera must be configured to upload events directly to EL from the WiFi base.
See your EL online help.
l Recorded events are uploaded to EL
l EL sends commands and requests to the camera as applicable:
l Mark any imported recorded events as import confirmed
The events confirmed as imported are immediately unprotected. This makes the storage space available
to be reused.
l Stage a firmware upgrade
After staging, the upgrade is immediately applied to the camera.
The camera is ready for operation when you undock it from the WiFi base.
Charging the Battery
A full charge in the Transfer Station II or WiFi base can take up to 6 hours. The battery can run for
approximately 12 hours on a full charge, depending on the configuration and video resolution.
n Dock the camera with battery or just the stand-alone battery in the WiFi base or the Transfer Station II.
Tip: Before using the camera for the first time, fully charge the battery and configure the
camera.
Motorola Solutions recommends that you use the USB base (plugged into an outlet) or the Transfer Station
II inside your agency when fully charging the battery.
Charging a battery in a vehicle that's not running can impact the vehicle battery. For the best battery life
and fastest charging times, charge the Covert mode in a cool environment.
Important! If the ambient temperature gets too hot (40° / 104° F) the battery may stop
charging. Do not leave the camera and battery in a hot car.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
31
To Next Page
Loading...
