Docking the V300 Body-Worn Camera
Upgrading WiFi base Firmware
The Motorola Solutions V300 Body-Worn Camera automatically pulls firmware upgrades for the WiFi
base from Evidence Library (EL) when V300 is docked.
Note: EL can be set up to push new firmware automatically or you can pull it manually,
depending on your agency's configuration. For instructions, see your Evidence Library
Online Help.
WiFi base upgrade
Important! Do not remove the battery while the upgrade is in progress.
To upgrade the WiFi base:
1. Dock the V300 in the Transfer Station II.
2. Upload events.
EL
3. Undock the V300 Camera after the firmware upgrade is complete.
4. Dock the V300 Camera in the WiFi base in the vehicle.
WiFi base upgrade occurs automatically.
o
The amber LED blinks quickly.
o
When the upgrade is complete the amber LED blinks slowly.
5. Power cycle the in-car system so that the upgrade will take effect immediately.
Note: If you undock the camera before the upgrade is complete, the camera downloads
the upgrade the next time the camera is docked. The upgrade does not take effect until
the download is complete and the in-car system powers up.
If the camera is undocked after the upgrade and then quickly redocked, the amber LED
no longer shows. If the upgrade is already complete, no upgrade occurs. Return to step 4.
If the ignition is turned off, without completing the upgrade, the next time the camera is
docked, the upgrade process begins again
36
V300 Body-Worn Camera User Guide
WGD00169, Revision B
To Next Page
Loading...
