Assigning a Configuration and Officer and Checking Out
Assigning a Configuration and Officer
and Checking Out
Important! Before using the camera for the first time, fully charge and assign a
configuration and officer to the camera.
Depending on how your agency assigns its cameras, you may need to configure and assign the camera
each time it is checked out.
To configure the camera:
1. Dock the camera in the WiFi base or Transfer Station II connected to a computer with access to the
Evidence Library (EL).
2. Create and then assign a configuration and an officer to the docked camera using EL.
Caution: If you have the battery with attached camera docked, ensure that you remove
them together. Undocking one without the other can damage your data.
As a configuration is applied to the camera, the display shows CONFIG. The configuration update alert
sounds when the update is finished. The camera vibrates when the update completes.
Transfer Station II configuration
You can only create a Transfer Station II configuration in EL.
Some of the configuration properties you can set up for the V300 include:
l Agency or department name
l Officer preferences for indicators
l Time zone
l Recording group interaction
l Officer name and badge ID
l Recording preferences
l Device ID
l Power and storage-saving preferences
l Network preferences
l Event tags
See your EL Online Help for more information.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
33
To Next Page
Loading...
