Transfer Station II Configuration
1. Assign a Static IP Address or let your DHCP server assign its IP address
Note: Use a static IP address for easy access to the UI for troubleshooting.
2. Enter the Location of the Transfer Station II.
3. Enter a unique IP address for each Transfer Station II.
4. Enter the Station ID that identifies the current Transfer Station II. Station ID fields each have a 32-
character limit.
In the example, Transfer Station II uses Building 415 as the location and B as the Station ID.
EL uses these names to identify the individual V300 Cameras and location of the cameras.
Note: Motorola Solutions provides labels that assume an alphabetic Station ID
combined with slot numbers 1 through 8.
5. Enter your IP Config type, either Static or DHCP server assigned. For DHCP setup, see (page 76).
The first screen shows a Static configuration.
Note: Motorola Solutions recommends that you set up a pool of static IP addresses
that you assign to your Transfer Station II.
6. Complete the remainder of the settings.
V300 Body-Worn Camera User Guide
WGD00169, Revision B
75
To Next Page
Loading...
