7 - 10 LI2208 Product Reference Guide
Hand-Held Trigger Mode
Parameter # 8Ah
Select one of the following trigger modes for the linear imager:
•
Standard (Level) - A trigger pull activates decode processing. Decode processing continues until the bar
code decodes, you release the trigger, or the Decode Session Timeout occurs.
•
Presentation (Blink) - The digital scanner activates decode processing when it detects a bar code in its
field of view. After a period of non-use, the digital scanner enters a low power mode, in which the LEDs
turn off until the digital scanner senses motion.
•
Auto Aim - This trigger mode projects the red illumination when you lift the linear imager. A trigger pull
activates decode processing. After 2 seconds of inactivity the aiming pattern shuts off. (See Aiming
Illumination on page 7-13 to set the type of pattern when aiming.)
*Standard (Level)
(00h)
Presentation (Blink)
(07h)
Auto Aim
(09h)
To Next Page
Loading...
