SCANNING 2 - 5
Hands-Free Scanning
Unless hands-free mode is disabled by scanning Hands-Free (Presentation) Trigger Mode on page 7-11, the
linear imager is in hands-free (presentation) mode when it sits in the gooseneck stand. In this mode the linear
imager operates in continuous (constant-on) mode, where it automatically decodes a bar code presented in the
field of view. The scanner LED is on, solid green.
To scan:
1. Ensure all connections are secure (see appropriate host chapter).
2. Present the bar code in the linear imager field of view.
Figure 2-2
Presentation Scanning
3. Upon successful decode, the linear imager beeps and the green LED momentarily turns off. (For more
information about beeper and LED definitions, see Table 2-1.)
To Next Page
Loading...
