5 - 2 LI2208 Product Reference Guide
Connecting to an IBM 468X/469X Host
This connection is made directly from the linear imager to the host interface.
Figure 5-1
IBM Direct Connection
To connect the IBM 46XX interface:
1. Attach the modular connector of the IBM 46XX interface cable to the host port on the bottom of the linear
imager.
2. Connect the other end of the IBM 46XX interface cable to the appropriate port on the host.
3. Select the port address by scanning the appropriate bar code from Port Address on page 5-4.
4. To modify any other parameter options, scan the appropriate bar codes in this chapter.
IMPORTANT The Auto-Host Detect Cable feature automatically detects the host interface type, but
there is no default setting. Scan one of the bar codes below to select the appropriate
port.
NOTE The only required configuration is the port number. Other linear imager parameters are typically
controlled by the IBM system.
To Next Page
Loading...
