3 - 22 LI2208 Product Reference Guide
Toshiba TEC Header Character
This single byte option specifies the header character prefixed onto the decoded data before transmission. The
default header character is the STX (0x02) character. Note that it is NOT POSSIBLE to use the NULL
character (0x00) as the prefix as this is the default value and indicates that an STX must be used. To program
a header character, scan the bar code below followed by two numeric bar codes in Appendix E, NUMERIC
BAR CODES.
Values:0 = Add STX (0x02),
All others specify the hex value to be prefixed.
Toshiba TEC Header Character
To Next Page
Loading...
