USB INTERFACE 3 - 15
Optional USB Parameters
If you configure the linear imager and find the settings were not saved, or changed, when the system is
restarted scan the bar codes that follow to override USB interface defaults.
Scan a bar code below after setting defaults and before configuring the linear imager.
Ignore Beep
The host can send a beep request to the linear imager. When this parameter is enabled, the request is not sent
to the attached linear imager. All directives are still acknowledged to the USB host as if it were processed.
Ignore Bar Code Configuration
The host has the ability to enable/disable code types. When this parameter is enabled, the request is not sent
to the attached linear imager. All directives are still acknowledged to the USB host as if it were processed.
*Disable
Enable
*Disable
Enable
To Next Page
Loading...
Need help?
General
