11 - 8 LI2208 Product Reference Guide
Special Commands
Pause Duration
Use this parameter, along with Send Pause on page 11-29, to insert a pause in the data transmission. Set the
pause by scanning a two-digit number (i.e., two bar codes) from Appendix E, NUMERIC BAR CODES in 0.1
second intervals. For example, scanning bar codes 0 and 1 inserts a 0.1 second pause; 0 and 5 inserts a 0.5
second delay. To correct an error or change a selection, scan Cancel on page E-3.
Pause Duration
Begin New Rule
Scan the bar code below to start entering a new rule
.
Begin New Rule
Save Rule
Scan the bar code below to save the rule.
Save Rule
To Next Page
Loading...
