USB INTERFACE 3 - 23
Toshiba TEC Terminator Character
This two byte option specifies the terminator character(s) appended onto the decoded data before
transmission. The default terminator character is the ETX (0x03) character. Note that it is NOT POSSIBLE to
use the NULL character (0x00) as either of the terminators as this is the default value and indicates that an
ETX must be used. If the first character is a NULL, then only the ETX is appended even if there is a second
character defined. If the desired terminator is ETX followed by another character, then BOTH characters must
be specified. To program a terminator character, scan the bar code below followed by two numeric bar codes in
Appendix E, NUMERIC BAR CODES.
Values: 0 = Add ETX (0x03),
All others specify the value to be appended in decimal format.
Toshiba TEC Light LED on Good Decode
This option specifies whether or not to light the Good Decode LED on a good decode.
Terminator Character 1
Terminator Character 2
* Light LED on Good Decode
Do Not Light LED on Good Decode
To Next Page
Loading...
Need help?
General
