IBM INTERFACE 5 - 5
Convert Unknown to Code 39
Scan a bar code below to enable or disable the conversion of unknown bar code type data to Code 39.
Optional IBM Parameters
If you configure the linear imager and find the settings were not saved, or changed, when the system is
restarted scan the bar codes that follow to override IBM interface defaults.
Scan a bar code below after setting defaults and before configuring the linear imager.
Ignore Beep
The host can send a beep request to the linear imager. When this parameter is enabled, the request is not sent
to the attached linear imager. All directives are still acknowledged to the IBM RS485 host as if it were
processed.
Enable Convert Unknown to Code 39
*Disable Convert Unknown to Code 39
*Disable
Enable
To Next Page
Loading...
Need help?
General
