2 - 2 LI2208 Product Reference Guide
Parameter Programming
Long low/long high beeps Red Input error, incorrect bar code or
Cancel
scanned,
wrong entry, incorrect bar code programming
sequence; remain in program mode.
High/low beeps Green Keyboard parameter selected. Enter value using bar
code keypad.
High/low/high/low beeps Green Successful program exit with change in the parameter
setting.
ADF Programming
Low/high/low beeps None ADF transmit error.
High/low beeps Green Number expected. Enter another digit. Add leading
zeros to the front if necessary.
Low/low beeps Green Alpha expected. Enter another alphabetic character or
scan the
End of Message
bar code.
High/high beeps Green Blinking ADF criteria or action is expected. Enter another criteria
or action or scan the
Save Rule
bar code.
High/low/low beeps Green All criteria or actions cleared for current rule, continue
entering rule.
High/low/high/low beeps Green
(turns off blinking)
Rule saved. Rule entry mode exited.
Long low/long high beeps Red Rule error. Entry error, wrong bar code scanned, or
criteria/action list is too long for a rule. Re-enter criteria
or action.
Low beep Green Deleted last saved rule. The current rule is left intact.
Low/high/high beeps Green All rules deleted.
Long low/long high/long
low/long high beeps
Red Out of rule memory. Erase some existing rules, then try
to save rule again.
Long low/long high/long
low beeps
Green
(turns off blinking)
Cancel rule entry. Rule entry mode exited because of an
error or the user asked to exit rule entry.
Code 39 Buffering
High/low beeps None New Code 39 data was entered into the buffer.
Three long high beeps None Code 39 buffer is full.
High/low/high beeps None The Code 39 buffer was erased/cleared.
Low/high/low beeps None The Code 39 buffer was erased or there was an attempt
to clear or transmit an empty buffer.
Low/high beeps None A successful transmission of buffered data.
Table 2-1
Scanner Beeper and LED Definitions (Continued)
Beeper Sequence LED Indication Indication
To Next Page
Loading...
