Getting Started 1 - 11
Insert the Battery
The battery resides in a chamber in the device handle.
To insert the battery:
1. Insert the battery into the battery well, top first, ensuring that the battery connectors touch the device
connectors inside the well.
2. Push down on the back of the battery until it snaps into place.
Figure 1-8
Battery Insertion
Connect the Cradle
Connecting the STB20XX Cradle
1. Insert the host interface cable into the cradle's USB/host port. See Figure 1-2 on page 1-4 and Figure 1-5 on
page 1-7.
2. Connect the other end of the host interface cable to the host.
3. If necessary, connect the power supply to the cradle's power port (if the interface requires, or to allow fast
charging of the device).
4. Connect the appropriate cable to the power supply and an AC power source, if necessary.
5. If applicable, insert the power supply cable ferrite into the support features on the cradle bottom and run the
host and power cables into their respective cable grooves.
6. For Bluetooth cradles only, pair the device to the cradle by scanning the pairing bar code on the cradle.
NOTE If the battery is completely discharged, and the unit is powered from a USB or RS232 cable, it may take up to
two hours for the unit to power up.There is no indication to the user of this condition and it may appear that the
unit is not charging and/or not working correctly. However, if the unit is placed in an STB2000 cradle with the
12V power supply power up is immediate.
CAUTION Avoid touching the contacts when positioning the battery.
IMPORTANT Connect the interface cable and power supply (if necessary) in the following order to ensure proper
operation of the device and cradle.
To Next Page
Loading...
