Advanced Data Formatting 14 - 31
Move Cursor
Scan a bar code below to move the cursor in relation to a specified character. Then enter a character by scanning
a bar code from the Alphanumeric Keyboard on page 14-91.
Skip Ahead “N” Characters
Scan one of these bar codes to select the number of positions
ahead to move the cursor.
14-33
Skip Back “N” Characters
Scan one of these bar codes to select the number of positions back
to move the cursor.
14-34
Send Preset Value
Send Values 1 through 6 by scanning the appropriate bar code. Set
these values using the prefix/suffix values in
Table 8-4 on page
8-19
.
Value 1 = Scan Suffix
Value 2 = Scan Prefix
Values 3-6 are not applicable
14-34
Table 14-2
Setup Field(s) Definitions (Continued)
Parameter Description Page Number
NOTE If there is no match and the rule fails, the next rule is checked.
Move Cursor To Character
Move Cursor To Start
Move Cursor Past Character
To Next Page
Loading...
