Symbol LS4278 Product Reference Guide9-8
Optional IBM Parameters
If you configure the scanner and find the settings were not saved, or changed, when the system is restarted scan the bar codes that
follow to override IBM interface defaults.
Scan a bar code below after setting defaults and before configuring the scanner.
Ignore Beep
The host can send a beep request to the scanner. When this parameter is enabled, the request is not sent to the attached scanner.
All directives are still acknowledged to the IBM RS485 host as if it were processed.
Ignore Bar Code Configuration
The host has the ability to enable/disable code types. When this parameter is enabled, the request is not sent to the attached scanner.
All directives are still acknowledged to the IBM RS485 host as if it were processed.
*Disable
Enable
*Disable
Enable
To Next Page
Loading...
