Getting Started 1-13
Inserting the Scanner in the Cradle
Insert the scanner in the cradle so that the metal contacts on the bottom of the scanner handle touch the contacts on the cradle. Push
the handle lightly to ensure a proper connection, engaging the contacts in the cradle and scanner. Ensure the desk/wall mount
converter knob on the back of the cradle is in the correct position for the horizontal or vertical mounting.
Horizontal Cradle Mount
When mounting the cradle horizontally, where no fastening is necessary:
1. Ensure the rubber feet are attached to the cradle. These feet provide traction and prevent surface damage.
2. Ensure the desk/wall mount converter knob is in the position shown in Figure 1-8.
Figure 1-8. Horizontal Mount - Inserting the Scanner in the Cradle
Vertical Cradle Mount
When mounting the cradle vertically:
1. Ensure the rubber feet are attached to the cradle. These feet provide traction and prevent surface damage.
2. Ensure the convertible mount hook on the front of the cradle is inserted with the hook facing up. If not, remove and reverse
the hook so that it is in position to secure the scanner in place. (See Figure 1-3 on page 1-6 for the location of the convertible
mount hook.)
3. Ensure the desk/wall mount converter knob is in the position shown in Figure 1-9.
Figure 1-9. Vertical Mount - Inserting the Scanner in the Cradle
Desk/Wall Mount
Converter Knob
Desk/Wall Mount
Converter Knob
To Next Page
Loading...
