Scanner Emulation Interface 11-7
Parameter Pass-Through
The Scanner Emulation host can process parameter bar code messages and send them to the attached decoder. In this way, customers
using Symbol compliant decoders can control the behavior of the entire system by scanning the necessary parameters only once.
For example, to enable D 2 of 5, scan the D 2 of 5 Enable parameter bar code. The scanner and the attached decoder both process
the parameter.
Convert Newer Code Types
The scanner supports a variety of code types that are not decodable by attached decoder systems. To allow compatibility in these
environments, the scanner converts these code types to more commonly decodable symbologies, as per the following chart.
Symbologies not listed on this chart are transmitted normally.
When decoding these code types with this parameter disabled, the scanner issues Convert Error beeps and transmits no data.
*Parameter Process and Pass-Through
Parameter Process Only
Scan this code type: Transmitted as:
Code 11 Code 39
Chinese 2 of 5 Code 39
GS1 DataBar (14, Limited, and Expanded) Code 128
Coupon Code Code 128
*Convert Newer Code Types
Reject Newer Code Types
To Next Page
Loading...
Need help?
General
