Wand Emulation Interface 10-5
Wand Emulation Parameter Defaults
Table 10-1 lists the defaults for Wand Emulation host types. To change any option, scan the appropriate bar code(s) provided in Wand
Emulation Host Parameters beginning on page page 10-6.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 10-1. Wand Emulation Default Table
Parameter Default Page Number
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface Controller
1
10-6
Leading Margin 80 msec 10-7
Polarity Bar High/Margin Low 10-8
Ignore Unknown Characters Send 10-8
Convert All Bar Codes to Code 39 Disable 10-9
Convert Code 39 to Full ASCII Disable 10-10
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
