Motorola Symbol LS4278 - Beep on Insertion; Intellistand Idle Timeout

User Preferences 5-7
Beep on Insertion
When a scanner is inserted into a cradle and detects power, it emits a short low beep. This feature is enabled by default.
To enable or disable beeping on insertion, scan the appropriate bar code below.
Intellistand Idle Timeout
While in Intellistand, the scanner enters low power mode when no bar code is decoded within 15 minutes. In the stand, this low
power mode is called Intellistand Idle Timeout.
The default Intellistand idle timeout is 15 minutes. The Intellistand idle timeout can be set to the following intervals:
• 5 minutes
• 10 minutes
• 15 minutes (default)
• 30 minutes
• 1 hour
• 2 hours.
When the scanner enters Intellistand Idle Timeout (low power mode in the stand), scanning capability
suspends. To restart scanning capability, press the trigger or remove the scanner and replace it into the stand.
Scan a bar code below to set the Intellistand idle timeout interval.
*Enable Beep on Insertion
Disable Beep on Insertion
5 min
10 min