Symbol LS4278 Product Reference Guide5-16
Synapse Interface
The auto-detection of a Synapse cable varies in duration depending on the type of Synapse connection. If a scanner is connected to
another scanner using a Synapse cable, use the Auxiliary Synapse Port connection. In all other cases, where the cable is used, the
default setting is recommended.
To disconnect and reconnect the scanner from a Synapse cable that is connected to a live host via a Synapse, use the "Plug and Play"
setting. Do not change this setting from the default if an on-board wedge host is enabled.
*Standard Synapse Connection
Auxiliary Synapse Port Connection
“Plug and Play” Synapse Connection
To Next Page
Loading...
