Scanning 2-5
Scanning in Hand-Held Mode
To program the scanner, see the appropriate host chapter, Chapter , Introduction 4-3 and Chapter 13, Symbologies. (In addition to the
parameters included in the chapters mentioned, user preference and miscellaneous scanner option parameters are also available in
this guide.)
To scan:
1. Aim the scanner at the bar code.
2. Press the trigger.
Figure 2-1. Scanning in Hand-Held Mode
3. Upon successful decode, the scanner beeps and the LED turns green. (For more information about beeper and LED
definitions, see Table 2-1 and Table 2-2.)
Scan line lengths vary depending on the scan line width selected (see Scan Line Width on page 5-11). A full
scan line width is the default. Medium and short scan line widths are useful for scanning menus or pick-lists.
Single-Line Mode Multi-Line Raster Mode
To Next Page
Loading...
