Scanner Emulation Interface 11-5
Scanner Emulation Parameter Defaults
Table 11-1 lists the defaults for the Scanner Emulation host. To change any option, scan the appropriate bar code(s) provided in the
Scanner Emulation Host Parameters section beginning on page page 11-6.
See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 11-1. Scanner Emulation Default Table
Parameter Default Page Number
Beep Style Beep on Successful Transmit 11-6
Parameter Pass-Through Parameter Process and Pass Through 11-7
Convert Newer Code Types Convert Newer Code Types 11-7
Module Width 20 µs 11-8
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to Code 39 11-8
Code 39 Full ASCII Conversion Disable 11-8
Transmission Timeout 3 sec 11-9
Ignore Unknown Characters Ignore Unknown Characters 11-10
Leading Margin 2 ms 11-10
Check for Decode LED Check for Decode LED 11-11
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
