Standard Default Parameters A-5
Convert Code 39 to Full ASCII Disable 10-10
Scanner Emulation
Beep Style Beep on Successful Transmit 11-6
Parameter Pass-Through Parameter Process and Pass
Through
11-7
Convert Newer Code Types Convert Newer Code Types 11-7
Module Width 20 µs 11-8
Convert All Bar Codes to Code 39 Do Not Convert Bar Codes to
Code 39
11-8
Code 39 Full ASCII Conversion Disable 11-8
Transmission Timeout 3 sec 11-9
Ignore Unknown Characters Ignore Unknown Characters 11-10
Leading Margin 2 ms 11-10
Check for Decode LED Check for Decode LED 11-11
123Scan Configuration Tool
123Scan Configuration None
1
12-3
UPC/EAN
UPC-A Enable 13-3
UPC-E Enable 13-7
UPC-E1 Disable 13-8
EAN-8/JAN 8 Enable 13-8
EAN-13/JAN 13 Enable 13-8
Bookland EAN Disable 13-9
Decode UPC/EAN/JAN Supplementals (2 and 5 digits) Ignore 13-10
Decode UPC/EAN/JAN Supplemental Redundancy 7 13-11
Transmit UPC-A Check Digit Enable 13-11
Transmit UPC-E Check Digit Enable 13-11
Transmit UPC-E1 Check Digit Enable 13-12
Table A-1. Standard Default Parameters Table (Continued)
Parameter Default Page Number
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
