Moxa Technologies IKS-G6524A - Page 31

Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
31
Syslog Server 1/2/3
Setting
Description
Factory Default
IP Address
Enter the IP address of Syslog server 1/2/3, used by your
network.
None
Port Destination
(1 to 65535)
Enter the UDP port of Syslog server 1/2/3. 514
NOTE
The f ollowing events will be recorded into the Moxa switch’s Event Log table, and will then be sent to the
specified Syslog Server:
• Cold start
• Warm start
• Conf iguration change activated
• Power 1 or 2 transition: Of f to On or On to Of f
• Authentication f ail
• Password change
• Redundancy protocol/topology change
• Master setting mismatch
• ABC-02 status
• Web log in
• Rate Limit on/of f (Disable port)
• Port looping
• Port traffic overload
• dot1x Auth Fail
• Port link of f /on
Relay Warning Status
When a relay warning is triggered by either the system or port events, the administrator can turn of f the
hardware warning buzzer by clicking the Apply button. The event will still be recorded in the event list.
NOTE
Relay 1 Alarm Cut-Of f (ACO) setting will not be changed by conf iguration f ile import.