Moxa Technologies IKS-G6524A - Page 40

Moxa Managed Ethernet Switch (UI_2.0_FW_5.x) User Manual
40
PoE System Configuration
NOTE
The conf iguration is dif f erent, depending on whether the “PoE power output managed by” item is set to
“Allocated Power” or “Measured Power.”
PoE Power Management by Allocated Power
PoE Power Management by Measured Power
PoE System Configuration Settings
PoE Power Output
Setting
Description
Factory Default
Enable
Enables PoE power transmission to a PD
Enable
Disable
Disables PoE power transmission to a PD
PoE power management Mode
Setting
Description
Factory Default
Allocated Power
If a powered device is connected that would cause the total
amount of power needed by all connected devices to exceed
the total allocated power limit, the switch will not power up
the device.
Disable
Measured Power
If a powered device is connected that would cause the total
amount of power needed by all connected devices to exceed
the total measured power limit, the switch with will deny
power to the device with the lowest priority.
Enable