MP Systems R Series - Installation

14 MPSYSTEMS-M-001/06
6. Installation
All MP SYSTEMS, R Series are shipped on wooden pallets designed for the safe transport of the R
Series auxiliary coolant and chip control system. A large MP SYSTEMS container protects the R
Series from any unnecessary damage during transportation.
6.1. Installation Kit Components
COMPONENT QUANTITY/LENGTH
Power Harness 1
Control Signal Harness 1
Jumper Plug for Signal Harness 1
Spare 5 Micron Filter Bag 2
Operation & Installation Manual 1
Inlet Dip Tube 1
Return Dip Tube 1
1 1/4" Diameter Inlet Hose 14’
1 1/4" Diameter Return Hose 14’
2” Hose Clamp 4
Weld Clamp (Mounting Dip Tubes) 2
Self-Taping Hex Screws (Mounting Weld Clamps) 2
Machine Tool Specific Installation Components 1
6.2. Recommended Tools for Installation
 Philips (Cross) Head Screwdriver
 Flat Blade Screwdriver
 Electric Drill
 7/8” UniBit (Step Drill)
 1 1/4" Conduit Punch or equivalent size hole saw
 12” Pipe Wrench (Minimum)
 Metric Hex Keys
 Teflon Pipe Tape / Liquid Pipe Sealant