6 Installation
Messko GmbH 202024 BA4001150/10 ENMSENSE
®
DGA 2/3
6 Installation
This chapter describes how to install and connect the device correctly.
DANGER
Electric shock!
Risk of fatal injury due to electrical voltage. Always observe the following
safety regulations when working in or on electrical equipment.
► Disconnect the system.
► Lock the system to prevent an unintentional restart.
► Ensure all poles are de-energized.
► Ground and short-circuit.
► Cover or cordon off adjacent energized parts.
NOTICE
Damage to the device!
Electrostatic discharge can lead to damage to the device.
► Take precautionary measures to prevent the build-up of electrostatic
charges on work surfaces and personnel.
6.1 Installation recommendation
Figure3: Installation recommendation
Recommended installation position
1 Side wall of the transformer, half way up
Alternative installation positions
2 Connection pipe from the cooling system to the transformer tank
To Next Page
Loading...
