MR MSENSE DGA 2 - Events

8 Operation
Messko GmbH 2020 63BA4001150/10 EN MSENSE
®
DGA 2/3
These limits and rates are suitable for initial commissioning. However, the
systems (transformer and device) must be aligned with each other over time.
Thus, with sufficient data, the limits / formation rates for the "warning" and
"alarm" values should be able to be calculated and loaded via the
MESSKO®MSET parameterization software.
8.1.3 Events
If a set warning or alarm limit is exceeded, this will be shown on the display
in rotation with the measured values (CO[ppm], H2[ppm], H2O[ppm/%RH],
Oil[°C]) as follows:
Figure43: Warning
Figure44: Measured values