9 Fault elimination
Messko GmbH 2020 65BA4001150/10 EN MSENSE
®
DGA 2/3
9 Fault elimination
This chapter describes how to eliminate operating faults.
If a solution cannot be found for a fault, contact Maschinenfabrik Reinhausen
GmbH:
Maschinenfabrik Reinhausen GmbH
MR Service & Complaint
Falkensteinstrasse 8
93059 Regensburg
Germany
E-mail: service@reinhausen.com
E-mail: complaint@reinhausen.com
Please have the following data to hand:
▪ Serial number
▪ Software version
Please have the answers to the following questions ready:
▪ Has the software been updated?
▪ Has there previously been a problem with this device?
▪ Have you previously contacted Maschinenfabrik Reinhausen about this is-
sue? If yes, then who was the contact?
9.1 Messages regarding the safety switching contact
Depending on the fault cause, the safety switching contact (fail-safe relay
FSR) reacts with a delay time of approx. 7…60 seconds.
State Contact 25-26 Contact 26-27
Idle state Closed Open
Fault Open Closed
To Next Page
Loading...
