MR MSENSE DGA 2 - Page 27

6 Installation
Messko GmbH 2020 27BA4001150/10 EN MSENSE
®
DGA 2/3
4. Pull the dummy plug out.
Figure7: Pulling the dummy plug out
Package the dummy plug and store safely in case the MSENSE® DGA is to
be removed at a later date.
5. Turn the ball valve lever to the "closed" position.
Figure8: Closing the ball valve
NOTICE
Missing or incorrectly positioned round gasket
Non-tight seal and possible oil leakage.
► Ensure that all round gaskets remain in position in the ball valve when lu-
bricating.