Chapter 5: Configuration Using the Web Interface
Topics:
Logging onto the Web Browser Interface
Configuration screen
Status Tab
Tools Tab
Settings Tab
This chapter describes how to configure an IMPACT network device using a web browser. Please note
that screenshots may vary slightly from those shown, depending on your current firmware version.
The IMPACT NS50 and WAP have a built-in web-server that is accessible by a PC to configure settings.
A PC can access the web browser interface by making a TCP/IP connection to the device. For more
information, see Connecting a PC to an IMPACT Network Device on page 114.
The IP address of the network device can be located and configured using the MST Device Scanner
tool. For more information on how to use the Device Scanner, see Device Discovery on page 108.