MST Impact NS5001 User Manual

NS50 wireless network switch
User Manual
Revision C
Chapter 5: Configuration Using the Web Interface
© 2012 MST Global
Commercial in Confidence
60
Self Check Settings
To enable automatic configuration from a TFTP server, tick the Self check enabled checkbox, enter the
desired Self check interval and TFTP Server Address, then click the Save Settings button.
Change Numbers
The two change numbers shown here are timestamps (formatted as YYYYMMDDhhmmss) showing the
last time the device's settings were updated via TFTP. The Site Change Number refers to general site
settings applied to all devices, whereas the Device Change Number refers to specific settings applied
to this device.
5.5.2 Configuring SNMP Settings
The SNMP screen contains Simple Network Management Protocol settings. SNMP is a protocol used by
the ICA and 3rd party SNMP browsers to monitor the status of compatible devices on the network. At

MST Impact NS5001 Specifications

General

Brand	MST
Model	Impact NS5001
Category	Switch
Language	English