EasyManuals Logo

MST Impact NS5001 User Manual

MST Impact NS5001
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
NS50 wireless network switch
User Manual
Revision C
Chapter 3: Installation
© 2012 MST Global
Commercial in Confidence
31
3.10 Connecting Antennas to the NS50
Antennas can be connected directly to the coaxial (RP-TNC) jacks on the unit or mounted remotely by
using coaxial cables. Coaxial cable length should be kept as short as possible (ideally less than 10m) to
minimise signal loss.
IMPORTANT: All cable and antenna connections must be electrically insulated using self-
amalgamating rubber tape.
The following procedure describes how to connect a coaxial cable to the NS50 and electrically insulate
the connection.

Table of Contents

Other manuals for MST Impact NS5001

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MST Impact NS5001 and is the answer not in the manual?

MST Impact NS5001 Specifications

General IconGeneral
BrandMST
ModelImpact NS5001
CategorySwitch
LanguageEnglish

Related product manuals