Multicomp-Pro
When OFF is shown, click to turn on the function, and enter the menu.
When ON is shown and unselected, click to enter the menu, click again to turn
off.
Set the channel status: Click the channel on the left bottom of the display
area, you can turn on, select or turn off the channel. You can also touch the
channel pointer on the left side of the display area to make it in selected state.
Channel is off
Channel is on and selected
Channel is on
Selected
Unselected
Channel pointer
Set the horizontal and vertical position
Click in the area as shown in the figure below, the P icon will appear. Click
anywhere outside the icon to hide it.
Note: Swipe up/down or left/right in this area, you can make the icon appear and
control it.
To Next Page
Loading...
