Using Drivers and Software
- 44 -
Method to set Scan To Local PC
To execute Scan To Local PC, you need to register
the computer name, IP address and port number
in the machine.
After installing the scanner driver, start Network
Configuration and select the driver to be used.
Then, select [Properties] from the [Scanner]
menu and select the [Register] tab. As the
computer information, the computer name, IP
address and port number are displayed. The
computer name does not have to be set since the
computer's host name is automatically acquired.
Although the setting value of the computer is
automatically displayed for the IP address, if
multiple network cards are installed in the
computer, multiple IP addresses are displayed.
Select the IP address of the network card
currently used. Further more, for the port
number, the current setting is displayed. If you
need to change, change the setting.
After all settings are complete. Click [Register]
button to register the setting in the machine.
If the machine is tuned off and cannot be
connected, an error occurs when registering.
After registering, if the computer's name, IP
address or port number is changed, you need to
register again with the above procedure.
Method to delete network-con-
nected PCs of the machine
If you registered several network-connected PCs
in the machine, you can delete them.
Select [Properties] from the [Scanner] menu
and select [Unregister] tab. The registered
information is displayed. Select the registered
information to be deleted from the machine, and
click [Unregister] button.
To Next Page
Loading...
Need help?
General
