Advanced Operations for Scanning, Internet Faxing and Scanning to Fax Server
- 38 -
Setting the Compression Level
You can specify the appropriate compression
level.
1 On the [Scan Menu] screen, select the
scan mode you want and then press .
If you select [USB memory], go to step 3.
2 Press the to select [Scan setting]
and then press .
3 Press the to select the [Compression
Rate] and then press .
If you use the internet fax function, go to step 5.
4 Press the to select the color type
(Color, Mono etc.) and then press .
5 Press the to select the compression
level from [High], [Medium] or [Low]
and then press .
Memo
If you select [Mono (Binary)], you can select a
compression level from [High], [Medium] or [Raw].
Setting the Grayscale
When Grayscale is enabled, data scanned by
is not black-and-white (binary) but
grayscale (255 tones).
Note
This function is only for scanning. Internet FAX and Scan
to Fax Server cannot be used.
1 On the [Scan Menu] screen, select the
scan mode you want and then press .
If you select [USB memory], go to step 3.
2 Press the to select [Scan setting]
and then press .
3 Press the to select the [Grayscale]
and then press .
4 Press the to select [ON] and then
press .
OK
OK
OK
OK
OK
MONO
OK
OK
OK
OK
To Next Page
Loading...
Need help?
General
