Myron L 750 II Series - Range Selection Guide

RANGE
Resistivity
0-20MΩ
0-10MΩ†
0-5MΩ†
0-2MΩ
0-1MΩ†
0-500KΩ†
0-200KΩ
Conductivity
0-1 µS*†
0-1 ppm*†
0-2 µS*†
0-2 ppm*†
0-5 µS*†
0-5 ppm*†
0-10 µS†
0-10 ppm†
0-20 µS
0-20 ppm
0-50 µS
0-50 ppm
0-100 µS
0-100 ppm
0-200 µS
0-200 ppm
0-500 µS
0-500 ppm
0-1000 µS
0-1000 ppm
0-2000 µS
0-2000 ppm
0-5000 µS††
0-5000 ppm††
0-10,000 µS/0-10 mS††
0-10,000 ppm/0-10 ppt††
0-20,000 µS/0-20 mS††
0-20,000 ppm/0-20 ppt††
0-50,000 µS/0-50 mS**††
0-50,000 ppm/0-50 ppm**††
0-100 mS**††
0-100 ppt**††
0-200 mS**††
0-200 ppt**††
756II, 757II, 758II & 759II
CONDUCTIVITY/TDS
Dash #
-101
-102
-103
-104
-105
-106
-107
-108
-109
-110
-111
-112
-113
-114
-115
-116
-117
-118
-119
-120
-121
-122
-123
-124
-125
-126
-127
-128
-129
-130
-131
-132
-133
-134
751II, 752II, 753II & 754II
RESISTIVITY
Dash #
-11
-12
-13
-14
-15
-16
-17
Add Range NUMBER below to instrument model number, i.e. 758II-”112” = 0-50 ppm Digital Monitor/controller.
G. 750 SERIES II RANGE SELECTION GUIDE
CONDUCTIVITY/TDS & RESISTIVITY
*CS51LC conductivity sensor (0. 1 constant) required for these ranges.
**CS52 conductivity sensor (10.0 constant) required for these ranges.
† Available in Digital models only.
†† Available with 4 1/2 Digit Backlit LCD. Other ranges available as OEM ONLY. Price & delivery on request.
Except as noted, Conductivity/TDS Monitor/controllers require a sensor with a cell constant of 1.0. The Model CS51 is the most
commonly selected sensor due to its ease of use and low cost.
Resistivity Monitor/controllers require a sensor with a cell constant of 0.05. The Model CS10 is the most common selected due to its
ease of use and low cost.
NOTE:UNLESSppm/NaClisspeciedwithorder,TDS/ppmtypeconductivityinstrumentswillbecalibratedtotheMyronL“442™”
Natural Water standard. For NaCl ppm/ppt add the letter “N” after the number, i.e. -124N.
8