NAPCO Security Systems
GEM-P1632 Programming Instructions
WI897B 8/98
Page 39
Enter an identifying description for each
zone. Buttons
and
set the
cursor position; buttons
and
scroll numbers, letters, punctuation marks,
etc.
Position the cursor over the displayed
Zone Number (i.e., “01”) using buttons
and
.
Change the Zone Number using buttons
and
.
Position the cursor over the first
character of the description field.
Advancing the cursor between
characters, program a description of up
to two lines for the new zone using
buttons
and
.
Press the
button to save. Advance to the next zone as in Steps 1 and 2 above and repeat this procedure until all zones have
been programmed.
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press
button.
Press the
button to save the code in memory.
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT (
) button or the
PRIOR (
) button.
GEM-RP2ASe2 Keypad
(Direct Entry)
USER PROGRAM MODE
Programming User Codes
To Program User Codes
1. Enter 2-digit User Number
(01-32) directly using
number buttons (0-9).
2. Press the
button.
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
button to save
each code.
NOTE:
Press
button to clear character at cursor.
To continue press
or
button.
Programming Zone Descriptions
To Program Zone Descriptions
1. Set the Cursor Position using
buttons
and
.
2. Select characters for zone
description using buttons
and
.
4. Press the
button to save
each descriptor.
NOTE:
Press
button to clear character at cursor.
To continue press
or
button.
To Next Page
Loading...
Need help?
General
