GEM-P1632 Programming Instructions
NAPCO Security Systems
WI897B 8/98
Page 58
GLOSSARY
Priority Zone with Bypass
A Priority Zone that will permit arming if the priority condition is bypassed. If the system is so programmed, the zone will auto-bypass
and (optional) the condition will be reported to a central station.
As above, if an attempt is made to arm, the sounder will come on and “
"
” will be displayed. To reset the
keypad, press the
button; the display will read “
”. To arm the panel, press the the
button, then enter the User
Code.
Any zone not selected as a Priority Zone may be programmed as a Priority Zone with Bypass.
Pulse Burglary Output
See Alarm Outputs
Receiver Format
The communicator can be programmed to transmit to any standard central-station receiver. A receiver format must be entered for
each telephone number used, but a different format may be assigned to each. Refer to Backup Report on Telco 2 and Report Telco 3
to determine whether or not Telephones 2 and/or 3 will be programmed. Call the central station for each telephone number used to
confirm the type of receiver in use. Select the receiver format entry for each telephone number from the following table.
*These formats do not use programmable
codes, but Event ID Codes to identify the type of zone as follows:
1 – Fire
2 – Panic
3 – Burglary
4 – Holdup
7 – Gas Alarm
8 – Heat Alarm
A – Auxiliary Alarm (keypad displays “0”)
B – 24-Hour Auxiliary Alarm
Relay Control (Optional External Relays)
In addition to the three relay outputs (Bell, PGM1 and PGM2) provided on the motherboard, up to 8 external relays can be controlled
from the keypad through the use of the RM3008 Relay Module. The RM3008 is designed for external remote mounting. One module
is needed for the GEM-P1632 Control Panel. Sixteen relay events (Address 0750-0829) can be assigned to any of the 8 available
external relays from Relay Module RM3008. Multiple relay events can drive the same External Relay.
ENTRY RECEIVER FORMAT
blank (•) Ademco, Silent Knight Slow
1 Sescoa, Vertex, DCI, Franklin Fast
2 Radionics Fast
3 Silent Knight Fast
4 Radionics, DCI, Franklin Slow
5 Universal Hi-Speed
8 Radionics BFSK
9 4/3/1*
A Radionics Modem 2*
BSIA*
C Point ID*
DATA
FREQ.
(Hz)
DUTY CYCLE
(ON/OFF)
INTERDIGIT
TIME
1900 60/40mS 600mS
1800 30/20 800
1850 13/12 400
1900 40/30 560
1800 60/40 600
1850 30/20 350
Modem formats
D Express (touch-tone 4/2 format)
To Next Page
Loading...
Need help?
General
